Basic Info.
Usage
Fishing, Drifting, Racing
Engine Capacity
700-900CC
Trademark
qingdao zhenbo yachat
Origin
Qingdao Shandong, China
Product Description
Installation and removal
Note: Do not use compressed air pump inflator (such as tires charge pump), because hyperinflation will destroy the rubber boats caught and waterproof membrane
First, the installation method
1. Before installing or removing rubber boats, have to clean up the nearby hard object;
2. The open and flat boats, the best temperature is 60 degrees Fahrenheit;
3. Checkers spring lever to close the valve live, counterclockwise until the spring rod protruding;
(Note: The first pneumatic valve closed should live, safety valve automatically when inflated excessive exhaust to protect the rubber boats)
4. Use the air pump to each side of the boat inflatable tube on average, after the completion of the inflatable safety valve will live too much exhaust gas, in order to avoid damage to hull cracks and waterproof protective film.
(Note that the air is not filled before, do not install the bracket and seat)
Second, install the pedal: Inflatable half after easy installation
Note that when you install the pedal, the board must up
2. # 1 plate mounted at the bow and position to be correct
No. 2. # 3 plate mounted on the stern
3. # 2 plate mounted on the # on the 1st of the clip board
4. # 2 and # 3 plate plate to be installed in the correct position and press down firmly steady
Third, the aluminum frame installation
1. Bottom side with oars will hold, secure mounting bracket installed on the other side while rearm
2. Install the seat
3. Follow the instructions below first bow before sufficient enough gas to other parts of the
4. Install the oars
Four. Inflating and deflating
1. Or use the included foot pump with adjustable pressure and switch electrical pump pneumatic, manual air pressure according to the factory
2. The maximum pressure is: Hull 3.5psi (0.25bar) and ship 5.5psi (0.35bar)
IMPORTANT
Climate and mode of operation will affect the ship's air pressure, heat rises and cold will decline, as long storage, the best part is that the gas discharge
Tip: Do not use the charge pump inflated tires, because the exhaust gas is too easy to damage the hull cracks and waterproofing membranes
3. Inflatable and exhaust, each gas exhaust pipe to be evenly inflated and to avoid damage to the exhaust valve.
Five demolition: Note hull should clean and dry
1. Open the valve and the pressure of all the living spring rod and locked in a clockwise direction
2. Remove the corresponding bit
3. The case of aluminum pedals, aluminum bracket removal, demolition after the middle of the pedal board and the ship-breaking head transom
Articles of gas pipe gas 4. Foot pump boat all out
5. The bottom down like, first off to the sides of the ship hull from bow to stern and then fold
6. Stored in a clean dry place boat, hull damage small animal care
Reference
To wear life jackets when the majority of countries and regions have provisions for children in the use of various water activities (such as rubber boats, etc. ); 1. Each user should wear appropriate clothes and put on life jackets and bear good or carry a floating equipment.
2. Note that before using rubber boats must be equipped with the necessary basic equipment such as oars, air pump, etc., if additional lifesaving equipment better.
3. After drinking or taking drugs was best not to use inflatables.
4. The weight of the boat to be average, as in the use of the aft engine not convex then accelerate or decelerate, which may vary to hull rupture.
5. No overload and stern boat load should not exceed the factory machine power requirements.
6. Attention to wind direction, wind speed and tidal use, because these are the poop machine will affect gasoline consumption.
Address:
No. 1, Jufu Road, Guhe Subdistrict, Laixi, Qingdao, Shandong, China
Business Type:
Manufacturer/Factory
Business Range:
Sporting Goods & Recreation, Transportation
Company Introduction:
Established in 2010, Qingdao Zhenbo Yacht Co., Ltd. is a manufacturer specialized in the research, development and production of yachts, inflatable boats, fishing boats, drifting boats and so on. We are located in Qingdao, with convenient transportation access. All of our products comply with international quality standards and are greatly appreciated in a variety of different markets throughout the world.
As a result of our high quality products and outstanding customer service, we have gained a global sales network reaching all over the world.
If you are interested in any of our products or would like to discuss a customized order, please feel free to contact us. We are looking forward to forming successful business relationships with new clients around the world in the near future.